The commands can be found in the file uartcontrol.txt. Now you can control the Board via Rx/Tx (UART). Watt also works is the USBHIDbootKbd from the examples of the USBHostShieldLibrary2.0. So the code for the rfid writer is done, and works well - but only over the serial monitor (osx) / putty (win10). Remove the short-circuit between CS1 and GND. Connect a Keyboard over USB -> USB Host Shield -> Grab the pushed key (char) from the keyboard and write them to the rfid writer. Remove the USB connection from the Board. Select VS1000D -> Upload USB boot file and choose VS1000_B.RUNĬopy the file boot.img to the new drive with the Windows Explorer. Make the following settings and press USB Search: Nominal Size: 256 MByte Set CS1 to low: add a wire from GND to R5 (100k).Ĭonnect the Board to the PC via USB and press the Power button on the Board.Ĭheck the new drive. Furthermore it supports PS3, PS4, PS5, PS Buzz, Wii, Switch Pro and Xbox controllers. Supports HID devices, FTDI, ADK, ACM, PL2303, Bluetooth HID devices, SPP communication and mass storage devices. Remove all connections from the Breakout Board. Model Name/Number: Prototype Shield with Breadboard for Arduino UNO weight: 31g. Revision 2.0 of MAX3421E-based USB Host Shield Library. Software: Flash-Tool, VS1000 UART-Control Firmware The SparkFun USB-Host-Shield has additional connected Reset and GPX from the MAX3421E to the Arduino pins 7 and 8.įor a correct function of the USB Host Shield 2.0 Library from you have to initialize these pins in setup() before using the library.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |